Cooker
F07
The F07 error code on a Beko cooker indicates a fault with the oven temperature sensor (NTC sensor), meaning the appliance cannot accurately read or regulate the oven’s internal temperature. It’s a moderately serious fault — your oven will typically stop heating until the issue is resolved.
What does this error mean?
F07 signals that the oven’s NTC (Negative Temperature Coefficient) thermistor — the component that monitors internal oven temperature — has either failed, is reading an out-of-range value, or has a wiring fault between the sensor and the control board. The cooker’s control system throws this code as a safety measure to prevent overheating or underheating. In most cases, the hob burners or rings will still work normally, but the oven cavity will be disabled.
Est. repair cost
£15–£35 DIY NTC sensor replacement; £80–£150 professional repair (sensor/wiring); £150–£250+ if PCB replacement required
🔍 Likely causes
🛠️ Step-by-step fix
Power reset first: Switch the cooker off at the wall socket (or trip the circuit breaker), wait 5 minutes, then switch it back on. Restart the oven and check whether the F07 code clears — a transient glitch can trigger this error and a hard reset often resolves it.
Check the oven door seal: Inspect the rubber gasket around the oven door for tears, gaps, or hardening. A damaged seal causes heat loss and can affect temperature sensor readings. Replacement seals cost £10–£25 and clip or slide on without tools.
Locate the NTC sensor: On most Beko ovens, the NTC sensor is a small probe mounted inside the oven cavity, usually on the back wall or top-left corner, secured by one or two screws. Visually inspect it for obvious burn damage, discolouration, or a broken probe — do this with the appliance fully unplugged.
Test the NTC sensor resistance (if comfortable using a multimeter): Unplug the cooker, disconnect the sensor’s wiring plug, and test resistance across the two sensor terminals. A healthy Beko NTC sensor typically reads around 10,000 ohms (10kΩ) at room temperature (20–25°C). A reading of 0 (short) or OL/infinite (open circuit) confirms a failed sensor.
Replace the NTC sensor if faulty: Order a genuine Beko NTC sensor using your cooker’s model number (found on the rating plate inside the door frame). Parts cost £15–£35. Fit by unscrewing the old sensor, swapping the wiring connector, and securing the new sensor — no specialist tools required.
If the sensor tests fine but F07 persists, the fault lies with the wiring harness or control board (PCB). Do not attempt to repair the PCB yourself — contact a qualified appliance engineer at this point.
📞 When to call a professional
Call a qualified appliance repair engineer if the F07 error returns after a power reset and you are not confident testing or replacing the NTC sensor yourself, or if the sensor tests as healthy but the fault persists (indicating a wiring or PCB issue). When calling, quote the model number from your cooker’s rating plate and tell the engineer: ‘F07 error code, suspected NTC temperature sensor or control board fault on a Beko electric oven.’
⚖️ Repair or replace?
A professional repair for an F07 fault — covering an NTC sensor or wiring fix — typically costs £80–£150 including labour and parts. If the control board (PCB) needs replacing, expect £150–£250+. For cookers under 7 years old in otherwise good condition, repair is almost always worth it. If your Beko cooker is over 8–10 years old and the PCB is at fault, replacement with a new mid-range cooker (£300–£500) is often the smarter long-term investment.