Tumble Dryer
F06
The F06 error code on an AEG tumble dryer indicates a fault with the door lock mechanism or door switch circuit — the appliance cannot confirm the door is properly closed and locked, so it refuses to run. It’s a common fault and often straightforward to resolve yourself.
What does this error mean?
When your AEG tumble dryer displays F06, the control board is not receiving a signal from the door lock assembly confirming the door is shut and secured. This is a safety interlock: the dryer is designed not to operate with an open or unlatched door. The fault could be mechanical (the latch itself), electrical (the switch or wiring), or simply a result of a software glitch that a reset will clear.
Est. repair cost
£8–£25 DIY (door latch or hinge part); £80–£150 professional repair including parts and labour
🔍 Likely causes
🛠️ Step-by-step fix
Reset the dryer: Switch the appliance off at the wall, wait 5 minutes, then power it back on. Attempt a new cycle — a transient glitch will clear at this stage.
Inspect the door seal and drum opening: Look for loose items (e.g. a sock) caught in the door seal or around the door frame that could prevent a proper close. Remove any obstruction and try again.
Check the door latch and strike: Open and close the door slowly and listen for a firm click. If the latch feels loose, wobbly, or doesn’t click, the catch mechanism is likely worn. Replacement door latch kits for AEG dryers cost £8–£20 from UK appliance parts suppliers and can be swapped with a screwdriver.
Examine the door hinge: Look for cracks or visible damage on the hinge that could cause misalignment. A sagging door will prevent the latch from engaging the strike correctly. Replacement hinges cost around £10–£25.
Test the door interlock switch (if comfortable doing so): With the dryer unplugged, the door switch is typically accessible by removing the front panel fascia (two to four screws). Use a multimeter set to continuity mode — the switch should show continuity when pressed and none when released. A failed switch costs £10–£30 to replace. If you’re not confident using a multimeter or removing panels, stop here and call an engineer.
Check wiring connections: With the dryer still unplugged, look for any visibly burnt, loose, or disconnected connectors on the wiring running to the door switch. Reseat any loose connectors firmly. Do not proceed further into the wiring loom — that requires a professional.
📞 When to call a professional
If resetting the machine, clearing obstructions, and replacing the door latch haven’t resolved the F06 error, the fault likely lies with the door interlock switch wiring or the main control board (PCB) — both of which require an engineer. Contact an appliance repair technician and tell them: ‘My AEG tumble dryer is showing an F06 error code, which I believe is a door lock fault — I’ve already checked the latch and reset the machine.’ This will save time and may reduce the call-out assessment.
⚖️ Repair or replace?
A professional repair for an F06 fault on an AEG tumble dryer typically costs £80–£150 including parts and labour in the UK. If your dryer is under 5 years old, repair is almost always worthwhile. For machines over 8–10 years old, weigh the repair cost against a new mid-range condenser or heat pump dryer (£300–£600) — if the repair exceeds 50% of a replacement’s cost, replacing is the smarter long-term choice.