Tumble Dryer
F07
The F07 error code on a Candy tumble dryer signals a fault with the motor circuit — specifically, the appliance is detecting that the drum motor is not running correctly or has stopped altogether. It’s a moderately serious fault that will prevent your dryer from operating until it’s resolved.
What does this error mean?
F07 indicates that the control board has detected an anomaly in the drum motor’s operation — either it’s drawing too much current, failing to start, or cutting out mid-cycle. On Candy (and sister brands Hoover and Haier) tumble dryers, the motor drives the drum rotation; without it, the machine cannot tumble clothes and will halt the cycle. The board logs F07 as a protective measure to prevent further damage to the motor or wiring.
Est. repair cost
£8–£15 DIY (belt or capacitor) | £100–£200 professional repair (motor or PCB)
🔍 Likely causes
🛠️ Step-by-step fix
Reset the machine: Switch the dryer off at the wall, wait 10 minutes to allow the motor thermal cut-out to reset, then switch back on and restart the cycle. If F07 clears, the motor had simply overheated — reduce your load size going forward.
Check the load size: Remove half the laundry and try again. Candy dryers typically handle 8–9 kg max — overloading is the most common trigger for motor faults.
Inspect and replace the drive belt: Unplug the dryer, remove the top and front panels (usually 2–3 screws and plastic clips), and check whether the belt is intact around the drum and motor pulley. A replacement belt for most Candy models costs £8–£15 and is a straightforward DIY job.
Check the drum for stiffness: With the belt removed, try rotating the drum by hand. It should spin smoothly with minimal resistance. If it grinds, squeaks, or feels stiff, the rear drum bearing or drum support rollers need replacing — this is a DIY-possible job but requires full disassembly.
Test the motor capacitor: If you’re comfortable using a multimeter, disconnect the capacitor (a small cylindrical component wired to the motor) and test its capacitance. A failed capacitor reads zero or wildly out of spec. Replacement capacitors cost £5–£12 and simply unplug and replug in.
If none of the above resolves F07, stop here: Do not attempt to open or bypass the motor’s wiring loom or the PCB. These steps require a qualified appliance engineer with the correct diagnostic tools.
📞 When to call a professional
If the belt and capacitor are fine, the drum spins freely, and F07 persists after a reset, you likely have a failed motor or a PCB fault — both require a professional repair. Call a Candy-approved or independent appliance engineer and tell them you have a persistent F07 motor fault that remains after checking the belt, bearings, and capacitor. This gives them a head start and may reduce diagnostic time and cost.
⚖️ Repair or replace?
A professional motor replacement on a Candy tumble dryer typically costs £100–£180 all-in for parts and labour; a PCB repair or replacement can run £120–£200. If your dryer is under 5 years old, repair is almost always worth it. If it’s 8 years or older and the motor has failed, a new mid-range condenser or heat pump dryer (£250–£450) is likely the better long-term investment — newer models are significantly more energy-efficient, which matters with UK electricity costs.