Washing Machine
E111
The E111 error code on a Beko washing machine indicates a communication fault between the main control board and the motor control unit (also called the inverter board). It’s a moderately serious fault — the machine will stop mid-cycle and won’t restart until the issue is resolved.
What does this error mean?
E111 signals that the main PCB (printed circuit board) has lost communication with the motor drive or inverter board — the component that controls drum speed and direction. Beko washing machines with brushless inverter motors rely on a continuous data signal between these two boards; when that signal drops or returns an unexpected value, E111 is triggered. The machine locks out as a safety measure to prevent the drum running out of control.
Est. repair cost
£80–£150 professional repair (inverter board + labour); £25–£60 DIY inverter board part only if self-replacing
🔍 Likely causes
🛠️ Step-by-step fix
Perform a hard reset first: switch the machine off at the wall socket, leave it unplugged for 10–15 minutes, then plug back in and run a short cycle. A temporary power glitch can trigger E111 and a full power reset often clears it.
Check your home’s consumer unit for a tripped RCD or circuit breaker on the washing machine circuit. Reset it if tripped, then test the machine again.
Pull the machine away from the wall and inspect the wiring harness at the back. Look for any visibly pinched, burnt, or chafed cables between the machine body and the back panel. Do not open the casing — if external cables look fine, move to step 4.
Run a diagnostic cycle if your Beko model supports one (hold the Start/Pause button for 3 seconds with the programme dial at position 1 on some models — check your specific model’s manual). This can confirm whether E111 reappears consistently or was a one-off.
If E111 returns after a reset and there are no visible external wiring issues, the fault lies internally with the inverter board, main PCB, or motor. At this point, do not attempt to open the machine’s electronics yourself — call a qualified appliance engineer.
If you are confident identifying appliance parts and are comfortable with basic appliance disassembly (isolate from mains first), you can check that the ribbon/wiring connector between the two boards is fully seated. A partially unseated connector is a quick, free fix — but only attempt this if you are comfortable doing so safely with the machine fully unplugged.
📞 When to call a professional
Call an appliance engineer if the E111 code returns after a hard reset, or if your machine is less than 8 years old and otherwise in good condition — repair is likely worth it. Tell the engineer the exact error code (E111), your Beko model number (found on the door frame sticker), and whether the fault appeared mid-cycle or on start-up. Do not attempt to open or replace the PCB or inverter board yourself — these are live-voltage components when powered and must only be handled with the machine fully isolated.
⚖️ Repair or replace?
A professional repair for an E111 fault — typically an inverter board or wiring harness replacement — costs £80–£150 including parts and labour in the UK. If your Beko is under 7–8 years old, repair is almost always the better value. Machines over 8–10 years old approaching or exceeding the repair cost threshold are better replaced, as other components are likely to follow.